GAI-Tronics 234 Stanchion Assembly - Manual (Page 5)

Pub. 42004-194M
234 Stanchion Assembly and Model 234SBA Stanchion Broadcast Assembly Page 5 of 11
f:\standard ioms - current release\42004 instr. manuals\42004-194m.doc
11/12
Model 84501-201 and 84509-201 Stanchion Main Body Installation
1. If the concrete is not level, find the anchor rod at the highest point of the concrete, and screw one ¾-
inch heavy hex nut 1- 1/8 inches above the concrete surface (measuring to the top of the nut).
See Figure 5.
2. Adjust the remaining three hex nuts to be level with the first. Place one washer over each heavy hex
nut. See Figure 5 and Figure 6.
Figure 5. Exploded View
3. Before mounting the stanchion, unscrew the four security screws on the rear access panel, and remove
the panel.
4. Apply a small amount of clear RTV silicone sealant or equivalent to each screw thread to reduce the
possibility of rust forming in the screw threads.
N
OTE : GAI-Tronics Model 233-001 Security Screwdriver is required to remove security screws.
5. Place the stanchion on top of the four level, heavy hex nuts.
6. Entering through the rear access panel hole, place the four remaining washers on the anchor bolts, and
secure with the ¾-inch hex nuts. Do not install the access panel cover until the wiring is complete.