GAI-Tronics 234 Stanchion Assembly - Manual (Page 7)

Pub. 42004-194M
234 Stanchion Assembly and Model 234SBA Stanchion Broadcast Assembly Page 7 of 11
f:\standard ioms - current release\42004 instr. manuals\42004-194m.doc
11/12
Model 84503-30 x Stanchion Panel Light Installation
1. Align the stanchion panel light assembly inside the
stanchion as shown in Figure 7.
2. Model 84503-301: Extend the black (hot), the white
(neutral) and the green (ground) wires to the base of
the stanchion (these wires will be connected later,
along with the strobe wires, to the incoming power
wires in accordance with the electrical codes).
Model 84503-302: Extend the black (−) and the white
(+) wires to the base of the stanchion (these wires will
be connected later, along with the strobe wires, to the
incoming power wires in accordance with the
electrical codes).
3. Secure the light assembly with the two mounting
screws provided. Apply a small amount of clear RTV
silicone sealant or equivalent to each screw thread to
reduce the possibility of rust forming in the screw
threads.
Figure 7. Stanchion Panel Light Assembly