Hansol H530 - Manual (Page 11)

19 18
Troubleshooting
Check the power connection.
(Refer to page 4)
Power LED is off.
No picture.
Check the signal cable between monitor
and computer. (Refer to page 4)
Perform Auto_config .
Check the computer connection cable.
(Refer to page 4)
Check the computer power is on.
Message, "No signal."
is displayed on the
screen.
Screen looks to be run
down.
Screen is not clear.
Check the resolution and frequency of
computer and video card, and set up
again refer to the current monitor
mode and standard signal mode table.
Display is unstable and
trembling.
Type Amorphous active matrix super TFT LCD
Screen Size 38.1cm (Diagonal)
Maximum Resolution 1024 X 768 @ 75 Hz
Pixel Range 0.297 mm X 0.297 mm
Display Colors 262,144 Color
Contrast Rate 300 : 1
Visual Angle 70° / 70° / 55° / 60° (Left / Right / Up / Down)
Response Speed 25 ms
Brightness 250 cd/m2
Horizontal Frequency 60kHz (Max.)
Vertical Frequency 75 Hz (Max.)
Video Signal Analog RGB (0.714 Vpp) 75 ohm
Synchronous Signal Mode H, V Separate TTL Sync,
Maximum 35W
Power Saving Mode Under 5 W
MENU, SELECT/AUTO, POWER,
Input: 90/264V (50~60 Hz),
Output: 12V, 3A, 36W
VESA Standard
Safety Standard UL, CE, TUV, CB
EMI FCC
Low Radiation MPR-II
Environment TCO'99
Size and Weight 358 X 50.0 X 346 / 3.8 Kg
Specification
LCD
Panel
Synchro
nization
Model H530(
Video
Input
Power
Consumption
Control key Front Part
Wall Mount
Safety
Standard
& EMI
Dimension
Power Adapter
Remove attaches to the signal line
(Video extension cable and others)
and switch on.
Perform Clock and Adjust PHASE.
Switch off/on the monitor.