Harken 80.2ST Winche - Manual (Page 9)

9 Radial Winch 80.2 ST Installation and Maintenance Manual
ThedrillingcutouttemplateisavailableontheHarken ® website,www.harken.com
B. Remove the winch and drill the eight 10.2 mm diameter holes.
C. Bolt the base of the winch to the deck using eight M10 Socket Head (SH) bolts (not supplied
by Harken ® ), correctly chosen for the thickness and type of the boat deck. Consult the yard that
built the boat in case of doubt.
WARNING!
To install the winch on the deck, use only bolts in A4 stainless steel (DIN 267 part11).
Bolts made of other materials may not have sufficient strength or may corrode which can
result in winch pulling off deck suddenly and unexpectedly during high loads causing severe
injury or death.
NOTICE
To mount winches on the deck, do not use countersunk bolts.
Carry out Installation procedure then install the winch on the deck in the chosen position.
A. Position the base of the winch on the deck and mark the position of the holes or use the
drilling cut-out template at the point where you have decided to place the winch.
Below is a reduced scale diagram.
Ø233
44°
40°
37°
60°
37°
46°
50°
23°
Ø287
23°
final pinion
position
Ø10 n°8