Hoefer PS200HC - Manual (Page 17)

Power supply operation
Recommended leads:
• 4 mm (banana) plugs, fixed insulating sheaths,
which are found on most Hoefer equipment.
Will also accept:*
• 4 mm (banana) plugs, unsheathed or
retractable sheaths
• Stackable plugs
* Exposed metal surfaces on voltage leads can potentially
lead to electrical shocks. If using these types of voltage
leads, the following safety tips will reduce the risk of
electrical shock.
1. Turn off the power supply before connecting or discon-
necting the voltage leads.
2. Keep fingers away from metal components when
connecting or disconnecting the voltage leads.
•
p7
WARNING! Use only one hand
when making or breaking a
connection to avoid making a
complete circuit across your
chest. Also, while connecting
or disconnecting the leads, do
not allow any part of your body
to contact a grounded surface.
Make sure your other hand
is not touching anything that
grounds you.
WARNING! If you are in the
middle of a run and wish to
connect or disconnect the leads,
always turn the power supply off
(press START/STOP). Wait for
the display to read OFF, and the
high voltage light to turn off.