Hummer 2009 H2 - Manual (Page 148)

Your panel of switches may not appear exactly as
they do in the examples above, but they should
be similar.
The switch positions on your hand-held transmitter
may be labeled, as follows:
• A switch in the up position may be labeled
as “Up,” “+,” or “On.”
• A switch in the down position may be labeled
as “Down,” “
− ,” or “Off.”
• A switch in the middle position may be labeled
as “Middle,” “0,” or “Neutral.”
2. Write down the eight to 12 switch settings from left
to right as follows:
• When a switch is in the up position, write “Right.”
• When a switch is in the down position,
write “Left.”
• If a switch is set between the up and down
position, write “Middle.”
The switch settings that you wrote down in
Step 2 will now become the button strokes you
enter into the Universal Home Remote in Step 4.
Be sure to enter the switch settings that you wrote
down in Step 2, in order from left to right, into
the Universal Home Remote, when completing
Step 4.
3. From inside your vehicle, first firmly press all three
buttons at the same time for about three seconds.
Release the buttons to put the Universal Home
Remote into programming mode.
Example of Eight Dip Switches with Three Positions
2-62