Troubleshooting – ilve Freestanding Cookers User Manual

Page 64

Advertising
background image

PROBLEM

ANSWER

COOKTOPS

My burners will not ignite

• Check to see if the brass burners are placed correctly into the aluminium base. This is very

important as it will ensure the flame holes line up with the ignition post and spark. It will also

ensure correct combustion when alight.

• Does your ILVE cooktop have flame failure devices fitted? Ensure burners are located correctly

as above. When burner is lit, ensure knob is firmly depressed for 5 to 10 seconds.

Does your ILVE cooktop have

flame failure devices fitted?

Ensure burners are located correctly as above. When burner is lit, ensure knob is firmly depressed

for 5 to 10 seconds. If new, ensure knobs are firmly fitted, check by pushing knobs down firmly

with the palm of your hand.

My ignition continually sparks

This may be due to a liquid spill over, which can cause moisture to enter into ignition micro

switches under knobs. Spraying liquid type cleaners can also create a problem. If this does

occur, the cooktop should be turned off at power point and left to dry out. Removing all knobs

and using a hair dryer on the control panel, will assist the drying out process.

All the igniters spark at the same

time when lighting

This is normal and how they are designed to operate.

The knob is loose on shaft

Knob retaining spring clip has come out. This does not require a service technician and can be

replaced by the customer. Please contact your ILVE state office, who will arrange for a clip to be

sent to you.

The burner is extinguished when

the cupboards or drawers are

opened or shut

In this case, the underside of the cooktop needs to be totally sealed off from the surrounding

cupboards or drawers.

The flame tips are yellow causing

the pots to blacken on the

underside

The gas type may be incorrect contact your installer and have him check the gas type and the

injector size and or the aeration needs adjusting see pages 40-41

The low flame is still to high

The low flame bypass screw needs to be adjusted contact your installer and have him adjust the

low flame setting as per the specification on page 41.

TROUBLESHOOTING

freest

anding cookers

64

ILVE Operating Manual

Advertising