InSinkErator WX-300 - Manual (Page 27)

28
PROPERTY DAMAGE
• Ensure that the control center voltage and phase
match the disposer motor and electrical supply.
Check nameplates on disposers and control
centers for voltage and phase specifi cation.
• The disposer motor wiring connection is shown in
the disposer terminal box.
120 V
1-phase
1/2 to 2 HP
380/460 V
3-phase
Call Toll Free 1-800-845-8345
for the nearest InSinkErator
Authorized Service Agency or
to reach Technical Support.
ELECTRICAL SHOCK
• Turn off the electrical supply to the disposer before
attempting any work on it. Use a voltmeter or
circuit tester to ensure that power is off.
• Installation must conform to local electrical codes.
• All components (disposer, WX, control center
and solenoids) must be carefully and permanently
grounded.
• A properly fused disconnect must be installed at
the electrical supply source for the control center.
Waste Xpress 380/460V, 3Phase System Wiring Diagram