Interlink Electronics MicroModule PS2 - Manual (Page 10)

www.interlinkelectronics.com
8
PS2 MicroModule
Integration Guide
6.0 Connection
Connection to MicroModule is accomplished via header J2 (Molex series #53261-0871), where
J2 provides the connection to the unit’s PS/2 interface (See Table 1 for header pin-out). The
integrator will need a cable with one female end (Molex series #51021) to mate to J2 and a
second end to mate to their desired interface (e.g., a PS/2 port, PCBA, etc.). Information on the
mating connector to MicroModule’s PCB header is given below for system integrators to
fabricate cables.
6.1 Molex Header/Mating Connector Specifications
The J2 header is a Molex series #53261-0871. Molex connector series #51021 is designed
to mate with this header. The metallic contacts that slip into the #51021 housing can be
either 50079-8 or 50058-8. The 50079 contacts accept wires AWG 26-28, and the 50058
contacts accept wires AWG 28-32.
Figure 7: MicroModule Connector (Molex Series 53261).