Jetway Computer NF9VT - Manual (Page 38)

33
User can set a value in the range of [10] to [4095].
WatchDog Timer Unit in ERP
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item displays current Emulate AT Power Status, motherboard power On/Off
control by power supply. User needs to select ‘AT or ATX Mode’ on MB jumper at
first (refer to Page 8~9, Jumper AT_MODE for ATX Mode & AT Mode Select).
 Serial Port Console Redirection
Press [Enter] to make settings for the following sub-items:
COM1/COM2/COM3/COM4
Console Redirection
Use this item to enable or disable COM1 Console Redirection.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], user can make further settings in the ‘Console Redirection
Settings’ screen:
 Console Redirection Settings
The settings specify how the host computer and the remote computer (which the
user is using) will exchange data. Both computers should have the same or
compatible settings.
Press [Enter] to make settings for the following sub-items.
Terminal Type
The optional settings are: [VT100]; [VT100+]; [VT-UTF8]; [ANSI].
Bits per second
The optional settings are: [9600]; [19200]; [38400]; [57600]; [115200].
Data Bits
The optional settings are: [7]; [8].
Parity
The optional settings are: [None]; [Even]; [Odd];[Mark]; [Space].
Stop Bits