Jetway Computer NF9VT - Manual (Page 40)

35
The optional settings are: [VT100]; [VT100+];[VT-UTF8];[ANSI].
Bits per second
The optional settings are: [9600]; [19200]; [57600]; [115200].
Flow Control
The optional settings are: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
 PC Health Status
Press [Enter] to view current hardware health status, set shutdown temperature, or
make further settings in ‘Smart Fan Configuration’.
 SmartFan Configuration
Press [Enter] to make settings for SmartFan Configuration:
CPUFAN / SYSFAN1/2 Smart Mode
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN1/2 Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN1/2 full speed temperature. Fan will run at
full speed when above this temperature.
CPUFAN / SYSFAN1/2 Full-Speed Duty
Use this item to set CPUFAN/SYSFAN1/2 full speed duty. Fan will run at full speed
when above the pre-set duty.
CPUFAN / SYSFAN1/2 Idle-Speed Temperature
Use this item to set CPUFAN/SYSFAN1/2 idle speed temperature. Fan will run at
idle speed when below this temperature.