Leprecon LP-900 - Manual (Page 10)

9
Leprecon/CAE, Inc. P.O. Box 430 Hamburg, Michigan 48139 810-231-9373
Leprecon®
Pro Lighting Equipment
THE LP-1000 SERIES OPERATIONAL INSTRUCTIONS
The LP-1000 series is a two scene console with a 12 channel preset configured
through a pin matrix. The LP-1000 also has a 6 channel chase, a bump system
that can change the existing look on stage momentarily, a output trim adjustment,
a minimum trim adjustment, a master section, a dipless crossfade and a
independent channel section. The LP-1000 series also has a 12 volt dimmable
gooseneck work lamp.
This controller uses a power source of 105-125 VAC 50-60 HZ and its output is a
continuous DC voltage to all channels.
POWER UP
When the power is applied to the controller the dimmable gooseneck work lamp
is immediately accessible. The 2.4 watt bulb is standard equipment in all of our
controllers. You can adjust the intensity of the lamp by a clockwise rotation of
the knob marked “lite”.
To engage or disengage the controller simply push the rocker switch marked
“on”. The green LED marked “power”, located beneath the switch, will be
glowing along with the switch itself.
If the LED or switch is not glowing recheck your power cord and be sure the
outlet that you are using is operational. If the outlet is operational and the power
is still not working, you may have an open breaker. The breaker reset is a red
button located next to the AC power cord.
TRIM
Under the “power” LED you will notice another green LED marked “max”. This
LED’s brightness is directly related to the amount of output voltage the controller
has been adjusted to. The factory trim adjustment is 10 volts, and the trim is
accessible from a recessed trim pot located next to the “max” LED. Under the
“max” trim control is another recessed control for the minimum output voltage,
this is marked “min” and is factory adjusted to zero volts. Do not readjust either
of these controls unless there is a reason for the adjustment, such as the
implementation of another brand of dimmer. Do this only in accordance with
factory instructions, which will be covered in detail under the trim adjustment
section.