Lumens Technology CL510 - Manual (Page 37)

English - 36
Chapter 8 Troubleshooting
This chapter describes problems you may encounter while using CL510. If you
have questions, please refer to related chapters and follow all the suggested
solutions. If the problem still occurred, please contact your distributor or the
service center.
No. Problems Solutions
1. Boot without power
signal Make sure you have plugged in the power cord.
2. There is no image
output from CL510 1. Check the power.
2. Check the settings for the source of the projector. For
the appropriate input selection of the projector, refer to
the projectors user manual.
3. Check if DIP Switch is properly set. Refer to Chapter 7
DIP Switch Settings for related settings.
3. Unable to focus 1. Probably the document is too close. Press [ZOOM -] on
the Remote Control. Or pull away the distance between
document and lens, then press [AUTO TUNE].
2. Please confirm if there is any fingerprint or stain on the
lens. Try to use [AUTO TUNE] to focus after cleaning
the lens.
4. The image is
incomplete Check the Auto Image setting of your projector. Please
refer to the user manual of the projector or check for the
DIP SWITCH settings.
5. Forget the password
for turning on Please contact your distributor or the service center.
6. Lumens Document
Camera, Ladibug™
and other
applications cannot
be used
simultaneously Lumens Document Camera, Lumens™ and other
applications cannot be executed simultaneously. Only one
application can be executed at a time. Please close the
currently running applications and then execute the
application to be used.
7. CL510 fails to store
images or react 1. Check to see if the stored data have reached the
maximum size of the USB device (priority) or internal
memory.
2. Please make sure if the Capture function is set to
Continuous mode or the time for capture is set to be
long. For the related setting, refer to
6.8 I would like
to capture images of Chapter 6 Descriptions of
major functions
.