1 installation 2. installation – MBM Corporation Maxxum 91 corner stapler User Manual
Page 4
Advertising
Corner Stapler Model 91 Operator Manual
T10125 September 2001
1. Fit the two studs (1) on the collator, using an Allen
wrench.
2. Push the Corner stapler fully up against the collator and
make sure that the two studs enters into the openings (2)
as this will position the Corner stapler sideways.
3. Make sure that the collator main power switch is set in
off position and attach the connection cable (3) between
the corner and the collator.
2.1 Installation
2. Installation
1
2
3
2-1
Advertising