Matters for special note, Hen not in use, Preparations before use – MBM Corporation HIGH CAPACITY STACKER User Manual
Page 7: Ssembly and installation of stacker
Advertising
3. Matters for special note
3.1 When not in use
・Be sure to remove the power plug from the outlet.
4. Preparations before use
4.1 Assembly and installation of stacker
(1) Assembly
Insert the paper butt unit in the square hole on the stacking
slide cover, and insert the gray connector into the plug of
the stacking slide cover.
(2) Installation
Set the stacker on the collator table at a position about 55
mm from its left edge.
(As for the exact position, fine adjustment should be made
when the forceful ejector is installed.)
- 6 -
Advertising