MBM Corporation HIGH CAPACITY STACKER - Manual (Page 9)

5. Operation
5.1 When the division option is set to ON
(1) Set the dolly on the dolly support.
The “UP” lamp lights.
Caution!
Push the dolly deep into the end and set it in the
correct position. The lamp will not light unless it is
properly set.
Danger
Do not your hand in the long hole of the slide plate and the machine while the dolly is moving up or
down. There is a danger that your hand may be caught in it.
(2) Loosen the adjusting knobs on the
right and left guides, and the butt
guide, and set them at appropriate
positions.
The drawing on the right shows the
case in which A4 size paper is used.
(3) Press the UP key and the dolly will automatically
move up to the prescribed position.
- 8 -