MEGA Corp. MAC-INSP-RSP-5 - Manual (Page 15)

MAC/MAT-INSP-RSP-5
4 Feb 2014
SECTION 3
Special Inspections
3-2
15. Turn drain ON.
16. Turn pump OFF.
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
17. Turn system OFF.
18. If equipped with a pneumatic spray system, drain
water separator filter inside solenoid control box.
19. If unit is equipped with a suction loading station,
ensure volute case petcock is OPEN.
20. If unit is equipped with front spray bar, ensure
spray bar drain is OPEN and water is not left in
hose.
21. If unit is equipped with a hose reel, unroll hose,
adjust discharge nozzle to OPEN, turn hose reel
gate valve(s) ON, and allow water to drain from
hose and rewind.
22. Check to ensure all water has drained from tank.
To restore unit to service from drained storage:
1. Lubricate water pump bearings as instructed in -2
manual. Inject 2 fl-oz.(60 cc) of grease in drive end
bearing grease fitting and 1 fl-oz. (30 cc) in the
impeller end bearing grease fitting and 4 to 5
injections of grease to lantern ring grease fitting.
2. Inspect tank interior to ensure it is clean, if the
tank is coated, ensure coating integrity, clean or
repair as required.
3. Install sump cover with new gasket.
4. Ensure water separator filter drain is closed if
equipped (Pneumatic system only if equipped).
5. Remove and clean hydraulic solenoid control box
filter before operating machine.
6. Start engine.
7. Turn system ON.
8. Turn pump ON.
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
9. Ensure all spray head controls are OFF.
10. Turn dump bar OFF.
11. Turn drain OFF.
12. Turn water cannon OFF.
13. Turn pump OFF.
Engaging/disengaging the water pump above
LOW IDLE may result in water pump component
damage and reduced service life.
14. Turn system OFF.
15. Turn engine OFF.
16. Close all drain valves and petcocks.