Mega Catch MCU-800 Ultra User Manual

Page 27

Advertising
background image

Replacement of U.V. Bulb (refer to figure 9.2):
Remove the U.V. Bulb by twisting the tube gently until it is able to be removed. Then slot a

new U.V. Bulb into the connector ends and twist the tube gently until it is firmly in position.

Reinstallation of Plates:
You should not have any reason to remove the plates from the Trap. If however you do, merely

slot the plates back into the ribs so that the Control Box is on the upper-side of the Top Plate

and the Fan is on the under-side of the Bottom Plate. There are arrows on each plate that

points to the back of the Trap (i.e. the half that does not contain the Timer) when the plates

have been properly installed.

Connection of Wires:
You should not have any reason to remove any of the electrical connections except as part

of the battery disposal process (see Page 26 - Removal of Timer section). All electrical

connections are by push-in pin connectors. Provided these are not forced it is not possible to

plug any connector into the wrong connector hole.
There are three connector holes on the underside of the Top Plate. The two smaller two-pin

connector holes are for the Fan and Heater Cables. These two connections are interchangeable

so it doesn’t matter which of these two connector holes the Fan and Heater are plugged into.

The third connection on the underside of the Top Plate is a three-pin hole and fits only the

U.V. Bulb Connection Cable. The connection holes into the Control Box on the upperside of the

Top Plate are all different sizes and fit the remaining cables.

Re-assembly of Trap:
With the Top and Bottom Plates in place replace the "timer-side" or top half of the Trap ensuring

that each plate slots into the locating ribs. The 12 screw holes should now be aligned for

replacement of the screws and nuts. Hold the nuts into the pre-formed hexagonal holes and

carefully screw in the screws.
(NOTE: Do not overtighten the screws. This could cause the nuts to rotate and damage the

pre-formed hexagonal fittings in the plastic housing.)

25

Advertising
This manual is related to the following products: