Metz MECABLITZ 36 AF-5 digital - Manual (Page 82)

ķ
82
batteries are of the same brand and type and have the
same capacity!
Exhausted batteries must not be thrown in the dustbin!
Help protect the environment and dispose of run-down
batteries at the appropriate collecting points.
4.3 Switching the flash unit on and off
The flash unit is switched on by its main switch. In the right
“ON” position, the mecablitz is on. To turn off the flash unit
reset the main switch to its “OFF” position.
4.4 Auto OFF for the flash unit
To save battery power and prevent inadvertent battery drain,
the flash unit is factory-set to automatically switch to standby
mode (Auto OFF) 10 minutes after
• being switched on,
• a flash is fired
• the shutter release is actuated
• the camera’s exposure metering system is switched off.
☞
...The green flash-ready light is extinguished.
The flash unit can be reactivated by pressing the shutter
release (wake up function).
The flash unit should always be turned off using the
main switch if it is not going to be used for an exten-
ded period.
5 Dedicated functions and flash mode
5.1 Flash readiness indication
The flash readiness symbol
lights up on the mecablitz
when the flash capacitor is charged, thereby indicating that
flashes can be fired for the next shot. Flash readiness is
transmitted to the camera and displayed in the viewfinder
(see camera manual).
If a picture is shot before flash readiness is signalled in the
camera’s viewfinder, then the flash unit will not be triggered
so that the exposure may be incorrect.
☞
709 47 0253.A1 36AF-5-CNOPS 28.06.2010 9:42 Uhr Seite 82