MicroE 1500S Mercury - Manual (Page 12)

Attach your hub/scale
assembly to the rotary
device. Refer to the
interface drawing. The
reflective surface of the
scale must face the sensor.
1
Page 10
3
Be sure power is off before
connecting the sensor.
Connect the M1500S to your
interface electronics using
the pinout diagram described
on the interface drawing.
Tighten the connector screws.
Power up the system.
2
Install the sensor on your mounting surface
referencing the appropriate datum surface as
shown on the interface drawing. Use 2 washers
per mounting screw.
Benching pins may be used to locate the sensor
if the system mechanical tolerances are adequate.
See data sheet for alignment tolerances, or keep
mounting screws loose for sensor alignment if
benching pins are not used.
Installation Instructions
Rotary Encoders - Using Sin/Cos Signals - Mounting