MicroLinks VT300 - user manual - Manual (Page 61)

Microscope Application Program http://www.ViTiny.com
Copyright ©2008-2012 MicroLinks Technology Corp.
Fig 5-69 Rectangle
(7) 3 Points Angle: Measure the angle on the object and use . In Fig. 5-70, it
can see an angle on the object, draw a line and stop at the corner of angle, and
then draw the other line from the angle; the angle can be automatically calculated.
a dot shows the measured angle, it is 135.5
o
.
Fig 5-70 3 Points Angle
(8) 3 Points Fillet: Measure charm and use . Draw first line on the angle (see
line A) and press the left mouse button to drag a line on the other side of the angle
(See line B) to calculate the chamfer. See Fig 5-71. There is a small dot
inside the chamfer and shows 45.8
o
.