MicroLinks VT300 - install manual - Manual (Page 11)

Microscope Installing http://www.ViTiny.com
11
Copyright © 2008-2012 MicroLinks Technology Corp.
3. Install and uninstall MICROSCOPE USB Driver
The driver is a must. If you do not install the driver, you can’t use MICROSCOPE AP.
3.1. Install driver
3.2.1Start to setup
Please select Fig.1-1, install driver program, to start Installing drive. Attention:
Please use the attached USB transmission line. Don’t use USB extension.
After click setup driver button, it will pop up Fig.3-1, now be ready to install the
window. If wish to cancel installation, please click “cancel” button.
Fig.3-1 Preparing to install