MMD Equipment 100S-6B4 - Manual (Page 11)

1. Safety
1-8
Fire prevention
Do not, under any circumstance, bring lit cigarettes or matches
near oils as engine oil and compressor oil, etc.
They are extremely flammable and dangerous.
Refilling oils should be done in an outdoor well-ventilated
place.
Refuel after stopping the engine, and never leave the fuel
nearby the machine. Do not spill. Clean environmental spills.
Such parts as muffler and exhaust pipe can be extremely hot.
Remove twigs, dried leaves, dried grass and waste paper, etc.
from the exhaust outlet of the muffler.
Keep a fire extinguisher available by the machine in case of a
fire.
D004
H990433
1.3 Caution during Inspection and Maintenance
Hang a “Now Checking and under Maintenance” tag
Remove the starter key from the starter switch before starting
inspection, and hang up a “Now Checking and under
Maintenance” tag where it can be easily seen. The checker
must keep the key during checking and maintenance.
Remove the negative (–) side cable from the battery.
SY001
Refilling of compressor oil
When you refill the separator receiver tank with compressor oil,
stop the engine, and make sure that the pressure gauge
indicates 0 psi (0 bar) and there is no residual pressure in it,
and then gradually loosen the oil filler cap for refilling oil.
Note residual pressure in the separator receiver tank could
force both extremely hot compressed air and oil to jet out and
you may be scalded or seriously injured.
W010