MMD Equipment 100S-6B4 - Manual (Page 27)

2. Operation
2-12
2.6.10 Check Wiring of Each Part
Check each wiring for any loose connection, damage to insulating sheathed portion, disconnection,
and short-circuit.
2.6.11 Check Piping of Each Part
Check each piping for any loose connection and also check each hose and pipe for any tear and leaks.
2.7 Unit Operation
Operation with compressed air supply port opened is prohibited
Do not operate the machine with service valves and relief valve
open unless air hoses and/or pipes are connected.
High-pressurized air blows out and its air pressure could cause
injury to the people nearby.
When the machine has to be unavoidably temporarily operated
with its port open, be sure to mount a silencer to reduce noise
and wear protective materials such as earplugs to prevent
damage to hearing. D003
Since this equipment is provided with a quick glow system (quick preheating device), you do not
have to turn the starter switch counterclockwise from STOP position.
Turn the starter switch to the “RUN” position, and the preheating will be completed in several
seconds and the preheating lamp will go out. Then, turn the Starter Switch to the Start position
to start up the engine.
When the engine is already warm, the preheating operation is automatically omitted. Even
though the preheating lamp lights up momentarily, ignore the lamp status, and start up the
engine.
WARNING – Because of the quick glow system, never use starting fluids to start engine.
Quick Glow System