Monster FlatScreen SuperThin Tilt Mount - Up to 27” Screens - Manual (Page 12)

12
masonry mounting (cont’d)
5
Position the wall mounting plate over the holes
drilled in the wall. Make sure the wall plate is
level by using the supplied bubble level. Place the
level on a ruler placed on top of the wall mounting
plate and confirm that it is vertically straight. Hold
the plate firmly in place.
4
Install the supplied plastic concrete anchors
in each hole. Tap into hole with hammer until
fully seated.
3
With your electric drill and ½" masonry bit,
pre-drill a 3" deep hole at each mark.