Montigo M38ODV ST - Manual (Page 11)

Page 11 XG0128
M38ODV-ST Direct Vented Fireplace
For Your Safety - READ BEFORE LIGHTING:
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
„ If you cannot reach your gas supplier, call the Fire
Department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified
service technician. Force or attempt to repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
A. This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
What To Do If You Smell Gas:
„ Do not try to light any appliance.
„ Do not touch any electrical switch; do not use any
phone in your building.
„ Immediately call your gas supplier from a
neighbour's phone. Follow the gas supplier's
instructions.
To Turn Off Gas To Appliance:
Operation - Model M38ODV-ST
3. Push in gas control knob slightly and turn
clockwise to "Off". Do not force.
4. Replace trim.
1. Turn off remote switch.
2. Remove lower trim.
1. STOP! Read the safety information above on this
label.
2. Remove lower trims.
3. Push in gas control knob and turn clockwise
to
"OFF."
4. Wait five (5) minutes to clear out any gas. Smell for
gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow
steps below.
6. Turn knob on gas control counterclockwise to
"PILOT."
7. Push in gas control knob completely and hold. Light
with Piezo Igniter button. Continue to hold the control
knob in for about (1) minute after
the pilot is lit. Release the knob
and it will pop back up. Pilot
should remain lit. If it goes out
repeat steps 3 through 8.
„ If knob does not pop up when
released. Stop and
immediately call your service technician
or gas supplier.
„ If the pilot will not stay lit after several tries, turn the
gas control knob to "OFF" and call your service
technician or gas supplier.
8. Push in gas control knob and turn counterclockwise
to "ON."
9. Replace lower trim.
10.Turn on remote switch to ignite fire.
Lighting Instructions:
with Continuous Pilot
NOTE: Knob cannot be turned from
"PILOT" to "OFF" unless knob is
pushed in slightly. Do not force.
Gas Control Knob
(Shown in "Pilot" postion.)