Montigo MD38 DV2 - Manual (Page 13)

Page 13
MD38-DV-2 Homefire
Part No. XG0111
Installation
Removing and Installing
the Door
Removing the Door:
Remove the trim (as described on the next page) to access the door
latches. Open the latches by pulling Part A upwards and towards you
to disengage Part B from the door. Lift Part B clear of the door.
Repeat for all three latches. Be sure to hold the door carefully so it
does not fall.
(See figure 23a.)
Once the three latches are unhinged, tilt the top of the door forward
and lift it out of the slots.
See figure 23b.
Figure 23a. Operating the door latches.
Figure 23b. Removing the door.
NOTES :
n If logs are not placed properly, excessive sooting will result.
n The surface of the logs will crack due to the heat from the
flames. This is a normal occurance.
Log 'D'
Log 'E'
Log 'A'
Log 'C' Log 'B'
Installing the Log Set
Installing the Logs:
The MD38-DV-2 is supplied with six ceramic fibre logs. Unpack the logs
and handle them very carefully.
1. Remove the door cover and the glass door.
2. Place the Back log onto the back log rest as shown below in figure
24a. The log has lip on the bottom which fits into the slot on the
log rest.
3. Place the Front log onto the front log rest as shown in figure 24a.
Center the log from side to side, and push it against the back of
the log rest. Carefully push the log onto the metal spikes on the
log rest.
4. Place the top logs in position as shown in figure 24b.
5. Start the fireplace. If the flame appears satisfactory, replace the
glass door and door cover.
Figure 24a. Positioning for the front and back logs.