Montigo MD38 DV2 - Manual (Page 14)

Page 14
MD38-DV-2 Homefire
Part No. XG0111
Log 'C' Log 'B'
Figure 25. Installing the horizontal trim pieces.
Installing the Trim
The fireplace is shipped with 6 horizontal trim pieces (3 upper and 3
lower), which must be field-installed.
Install the trim by placing the top edge of the trim over to the retainer
clips on either side of the fireplace. Push the bottom edge firmly
inwards and the trim will snap on.
(See figure 25)
Figure 24b. Proper log placement .
Installation
Operation
Lighting Instructions
See pages 15 and 16.
Burner Adjustment
The MD38-DV-2 Homefire Plus is equipped with adjustable burners,
allowing you to raise or lower the flames. Operating the control
knob as described below will adjust both the main burner and the
ember burner.
n
To raise the flame height, turn the black knob (located behind
the lower trim) counterclockwise.
n
To lower the flame height, turn clockwise.
Gas Control Knob
(Shown in "Pilot" postion.)
'Hi-Lo' Adjustment Knob
Figure 26. 'Hi-Lo' Adjustment on the MD38-DV-2's gas valve.