Montigo SP28 F2 - Manual (Page 10)

XG0318 Page 10
SP28-F2 Modular Series Fireplace
Figure 22. Installing the hood and filler plates.
Figure 23. Removing and installing the glass door.
Installation
10. Reconnect gas line by following the information on page 4.
11. Turn on the gas supply and leak test the connection using a soap
solution.
12. Install the new front bar as shown in figure 21.
Figure 21. Installing the new front bar.
13. Install the filler plates first and then the hood as shown in Figure 22.
Loosen the two adjustment screws on the mounting brackets. Hook
the bottom of the hood of the top edge of the Insert and slide the
mounting brackets into the holes on each side of the shell. Re-tighten
the adjustment screws.
14. Remove the glass door as shown in Figure 23. Remove the plastic
shipping ties and padding from the two bottom logs. Install the top
logs as shown in Figure 8b and 8c.
Re-install the door.