ONICON D-100 BACnet User Manual
Page 17
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
D-100 Display Module BACnet Installation and Operation Guide 05/14 - 0635-6 / 18341
Page 17
1.6.3 Changing the Gateway Address
Changing the gateway address requires the use of RUInet utility software and a PC with
an Ethernet card and an available port. Assuming the display is programmed with the
default address (192.168.1.24) the host PC must be configured to operate with an
IP address of 192.168.1.1 and a subnet mask of 255.255.255.0. RUInet is available for
download from the ONICON web site, www.onicon.com.
1.
Load RUInet and configure the PC as necessary.
2.
Connect an RJ45 Ethernet cable between the PC and the display and power the
D-100. Allow 60 seconds for the display firmware to cycle through start-up
diagnostic routines.
3.
Open RUInet.
4.
From the Remote User Interface main menu (shown below) select option “I”,
Change IP Address.