Orion System Digital Room v.1 - Manual (Page 6)

DIGITAL ROOM SENSOR
Operator Interface 6
Sensor Operation
Main Sensor Display Screens
There are 3 Main Sensor Display Screens. The fi rst screen displays
the Current Room Temperature or Cooling/Heating Setpoint, Opera-
tion Mode, Slide Offset, and RH (RH is available on the OE217-01
Model). The second screen displays the Outside Air Temperature and/
or Humidity if Outdoor Air Temperature and/or Outdoor Air Humidity
is being monitored. The third screen displays the unit information for
the controller that the Digital Room Sensor is connected to.
Temperature and Humidity Status
Screen
The Main Display Screen dis-
plays the current room tem-
perature or Cooling/Heating
Setpoint, the humidity in the
room (RH is available on the
OE217-01 Model), the current
setting of the slide offset, and
an icon for the current mode of
operation once the controller it is
connected to is done calibrating.
The different icons shown are a Snowfl ake for cooling mode, a Flame for
heating mode, a Fan in motion for vent mode, and a Moon for unoccupied
mode. When the unit is in unoccupied mode, the screen’s background
will turn dark. Refer to Figure 8 for operation mode screen examples.
Outside Air Temperature Humidity
Status Screen
If the connected controller is
receiving an outdoor air tempera-
ture and/or humidity broadcast,
touching
<Display>
will fi rst
bring up the Outdoor Status
Screen.
Unit Information Screen
Touching
<Display>
again will
bring up the Unit Information
Screen which contains the con-
troller’s address or ID number,
screen ID, and software version
of the controller connected to
the sensor.
Setpoint Adjust Screen
Touching <> or <> will dis-
play the Setpoint Adjust Screen.
You can adjust the cooling and
heating setpoints from this screen
based on the VCM-X controller
or VAV/Zone controller slide off-
set setpoint. For example, if the
connected controller’s Max Slide
Offset Setpoint is set for fi ve, you
can adjust the setpoint up fi ve
degrees and down fi ve degrees.
NOTE: If the VCM-X Controller or VAV/Zone Controller’s slide
offset setpoint is set to Zero, this screen will not appear
when you touch <> or <>.
Figure 8: Operation Mode Screens
Cooling Mode
with Snowfl ake Icon
Heating Mode
with Flame Icon
Vent Mode
with Fan in Motion Icon
Figure 4: Main Display
Screen
Figure 5: Outdoor Status
Screen
Figure 6: Unit
Information Screen
Figure 7: Setpoint Adjust
Screen
Unoccupied Mode
with Moon Icon