Paloma PH-28c Indoor and Outdoor - Manual (Page 8)

8
Installing the (OUTDOOR) water heater:
This water heater must be installed in accordance with these instructions, local codes, utility company
requirements, and/or in the absence of local codes, use the latest edition of the American National
Standard/National Fuel Gas Code. A copy can be purchased from either the American Gas Association, 400
North Capitol Street Northwest, Washington, DC 20001 as ANSI standard Z223.1 or National Fire Protection
Association, 1 Batterymarch Park, Quincy, MA 02269 as NFPA 54. In Canada, the latest edition of the CSA
B149.1 Natural Gas and Propane Installation, and the Canadian Electrical Code, CSA C22.1 Part 1, in the
absence of local codes.
Location of the OUTDOOR water heater
This water heater is for OUTDOOR
installation ONLY!
This water heater is an outdoor model
and must be mounted vertically. It
must not be installed indoors or in a
confined space.
The water heater should be installed
close to the most frequently used outlet
and its position chosen with safety and
service in mind.
Make sure people (particular children,
disabled, and elderly) will not touch the
hot water outlet or the flue terminal.
The flue terminal and air inlet must be
clear of obstruction and shrubbery.
The water heater should not be located
in an area where leakage of the heat
exchanger or connections will result in
damage to the area adjacent to it or to
lower floors of the structure.
A gas fired water heater or any other
appliance should not be installed
in a space where liquids which give off
flammable vapors are to be used or stored.
Such liquids include gasoline, LP gas
(butane or propane), paint or adhesives and
their thinners, solvents or removers.
Because of natural air movement in a
room or other enclosed space, flammable
vapors can be carried some distance from
where their liquids are being used or
stored. The open flame of the water
heater’s main burner can ignite these
vapors causing an explosion or fire which
may result in severe burns, death or
property damage.
The water heater must be located so it is
not subject to physical damage, for example,
by moving vehicles, area flooding, etc.
● The water heater should be installed
vertically with the water, gas, and power
connections on the underside pointing
toward the ground.
●
Failure to properly install the water
heater outdoors as outlined in this
manual can result in unsafe operation.
●
Hot and cold water lines should be
insulated to conserve water and energy.
●
The water heater and water lines should
be protected from exposure to freezing
temperatures.
●
Do not install water heater where
subject to vibrations.
●
Do not install the water heater in
Recreational Vehicles, Mobile Homes,
Boats and other Watercrafts.
●
Do not install the water heater near
vents for heating or cooling. A
minimum of 4 feet should be
maintained.
●
Minimum clearance from combustible
and noncombustible construction is
1/2” (1.3 cm) sides, 0” rear (with
support bracket); 12” (30 cm) from the
bottom; 12” (30 cm) from the front of
the water heater; and 12” (30 cm) from
the top (24” (61 cm) from front and top
is recommended for servicing
purposes). If the clearances stated on
the Instruction/Warning Label, located
on the front panel of the heater differ,
install the water heater according to the
clearances stated on the label.
WARNING: Combustible
construction refers to
adjacent walls and ceilings
and should not be confused
with combustible or
flammable products and
materials. Combustible
and/or flammable products
and materials should never
be stored in the vicinity of
this or any gas appliance.
!
min.
1/2 "
(1.3 cm)
min.
1/2 "
(1.3 cm)
min. 12" (30 cm)
(24" (61 cm) minimum is
recommended for service)
Top = 12" (30 cm)
Front = 12" (30 cm) Back = 0" (with support bracket)
Side = 1/2" (1.3 cm)
Bottom = 12" (30 cm)
Minimum Clearance from
Combustible and
Non-Combustible
Construction.