Paso Sound PDVD01U - Manual (Page 11)

TASCAM DV-D01UT/C
11
Connections
Do not connect the power cord until all other connections have been made.
Connecting a TV
Distortion of picture may occur when connecting to the TV
via a VCR, or to a TV with a built-in VCR.
You need to set “MONITOR TYPE” in the PICTURE menu
correctly according to the aspect ratio of your TV. (See page 26.)
To connect a conventional TV
The unit
Audio/video cable (supplied)
TV
To connect a TV equipped with the HDMI
terminal
HDMI connection allows you to enjoy high quality picture on
your HDMI equipped TV with high-definition digital video
signals.
You can select the type of video signal from 480p (NTSC),
576p (PAL), 1080i or 720p. (See page 10.)
TV
The unit
To HDMI input
HDMI cable (not supplied)
NOTE
This unit outputs the audio signal of 48 kHz, 44.1 kHz, or
32 kHz Linear PCM from HDMI terminal. Set “DIGITAL
AUDIO OUTPUT” in the AUDIO menu to “PCM ONLY”.
(See page 26.)
HDMI indicator lights on the display window when the unit
and the TV recognize each other and are ready to send and
receive signals.
When you enjoy HDCP contents, sound and picture may not
be transmitted to the speakers and TV for a few seconds in the
beginning for confirmation.
About DVD AUDIO
This unit outputs DVD AUDIO through either analog
AUDIO OUT or HDMI.
Down-mixed tracks output through AUDIO OUT (L/R).
If HDMI input on the device connected to this unit does
not support DVD AUDIO, the signal output through the
HDMI on this unit will be muted. •
•
•
What is HDMI?
The HDMI (High Definition Multimedia Interface) is the
standard interface for the next-generation TV. By connect-
ing this unit and a TV with the HDMI cable, digital video
signals and audio signals are transmitted through the cable.
You can enjoy digital video and sound without AD/DA
conversion with easy connection.
In addition, this unit is compatible with HDCP (High-
Bandwidth Digital Content Protection), and HDCP contents can
be viewed if you connect a HDCP compatible TV to this unit.
•
•
·
·
•
•
•
To connect a TV equipped with the
component video input jacks
With analog video connection, you can get better picture
quality in the order - Component video > S-video > Composite
video.
If your TV supports progressive video input, you can enjoy a
high quality picture by setting the progressive scan mode to
active. (See page 10.)
The unit
To component
video input
TV
Component video cable (supplied)
NOTE
While playing back DivX/ASF files, this unit outputs only
progressive signals from the component video jacks. When
your TV does not support progressive video input, connect the
TV through S-video or composite video jack.
If the component video input jacks of your TV are of the BNC
type, use a plug adapter (not supplied) to convert the pin plugs
to BNC plugs.
To connect a TV equipped with an S-video
jack
The unit
Audio cable (not supplied)
TV
S-video cable (not supplied)
To audio input To S-video
input
Align
the
T
marks.
·
•
•
•
•
·