Paso Sound PDVD01U - Manual (Page 12)

1
TASCAM DV-D01UT/C
Connections Do not connect the power cord until all other connections have been made.
Connecting to a stereo amplifier/
receiver
You can enjoy high-quality audio by connecting the unit’s audio
output to an amplifier or receiver.
Amplifier
or receiver
The unit
Audio cable
(not supplied)
NOTE
When using the unit with a stereo amplifier or receiver, set
“DOWN MIX” in the AUDIO menu to “STEREO”. (See page
27.)
Connecting to a digital
component
You can enhance the sound quality by connecting the unit’s
DIGITAL OUT (OPTICAL) to the digital input of an ampli-
fier by using an optional digital cable. If you connect the unit
to a Dolby Digital, DTS or MPEG multichannel decoder or
an amplifier with built-in decoder by using an optional digital
cable, you can enjoy high-quality surround sound.
With digital connection, depending on the disc type, there may
be no audio output from the digital output. It is advisable to also
make an analog connection.
Audio cable
(not supplied)
The unit
To audio input
Optical digital cable (not supplied)
Digital device
To digital optical input
•
NOTE
When you connect the unit’s DIGITAL OUT (OPTICAL) to
a digital audio device, before using, set “DIGITAL AUDIO
OUTPUT” in the AUDIO menu correctly according to the
connected audio device. If “DIGITAL AUDIO OUTPUT” is
not set correctly, loud noise may be generated from speakers,
causing damage to them. See “DIGITAL AUDIO OUTPUT”
on page 26.
When connecting this unit to a TV via HDMI and to an
amplifier using DIGITAL OUT (OPTICAL), set “DIGITAL
AUDIO OUTPUT” in the AUDIO menu to “PCM ONLY” to
enjoy sound from the TV. To enjoy sound from the amplifier,
set “DIGITAL AUDIO OUTPUT” to “STREAM/PCM”. (See
page 26.)
When you connect the unit’s DIGITAL OUT (OPTICAL) to
a Dolby Digital or DTS decoder (or amplifier with a built-in
decoder) to enjoy surround sound, the unit’s “D. RANGE
COMPRESSION” setting in the “AUDIO” menu is invalid.
Make appropriate surround audio settings on the decoder.
Connecting the power cord
Make sure that all other connections have been completed.
The unit
Power cable
(Supplied)
Plug into AC outlet
CAUTION
Disconnect the power cord before cleaning or moving the unit.
Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp and pull the plug so as not
to damage the cord.
RS-232C connector
Connect a suitable external device to control the unit using
RS-232C protocol. (See page 28.)
•
•
•
•
•
To audio input