Posiflex AURA-9000 - Manual (Page 10)

Page 10
Aura-9000L including changing the printer IP for application according to his
network administrator’s request. However, DHCP is not support.
Reset Pin Hole
As the setup for the Aura-9000L/W can be set freely, the changes are not well
registered some troubles could be introduced. Therefore, in Aura-9000L/W,
there is a “Reset pin hole” near the LAN connector or Wi-Fi Module. Use
something like a ball pen tip or straightened end of paper clip to push and hold
for at least 5 seconds into this hole will reset the LAN / Wi-Fi setup of the
printer back to the default values at delivery so the user may re-do all setup.
The LAN setup can be viewed in second paragraph of self-test printout for the
Aura-9000L.
LAN POS Printer Manager
This utility can be used to manage multiple Aura-9000L’s connected in same
network under Windows as long as there is no conflicting IP in the network.
This utility can assign to each LAN printer a different device name for easy
recognition. In case of confusion, please check the MAC addresses listed in
this utility against the MAC address label you can find under each printer.
Any PC connected in same network can use TCP/IP to use Aura-9000L in the
way like a directly connected local printer. So, for direct I/O control by tools
like “HyperTerminal” all commands applicable to the serial or parallel
interface model can work on Aura-9000L in the same way, as Aura-9000
except the port must be TCP/IP with the IP address of the printer. Similarly,
for Windows printer driver setup, please “Add Printer” and select for “Local
printer” and select port “TCP/IP” with the printer IP address then uses the
same Windows printer driver of Aura-9000L.
Posiflex Wi-Fi POS Printer Manager for Aura-9000W
When set the host system by AD-HOC mode; please set the host system IP in
the same network segment with Aura-9000W which in the 192.168.192.XXX.
Please set the Aura-9000 into normal mode that can be search by this printer
manager utility. After start the software, the host system will automatically
search printer by Broadcast or search by IP modes and show as a list. After
Aura-9000 showed in the list, the IP address setting can modify. Please notice
that Aura-9000W Wi-Fi module will reboot automatically right after change or
update setting. Finally set the host system back to original mode.
For modify the printer’s Wi-Fi setting through USB interface, please connect
the cable to USB port. It significant that when using USB interface to
regulate the Aura-9000W, please set the hardware DIP switch 1-6 or
software switch 1-6 to “ON”. After change or update setting, please set the