Posiflex AURA-9000 - Manual (Page 20)

Page 20
SW4-1 switch controlled the “Beep” sound after printing. Please select “ON”
if this beep sound is required and it will not make any sound after “OFF” is
selected.
Software switch SW4-2&3 is helping user to saving paper by reduce the
barcode height to 25%, 50% or 75% of the original size. Please refer to the
following table to change this switch’s setting.
Effect of positions 2 & 3 on Barcode Height Reduction as in table below:
SW4 Pos. 2 OFF ON OFF ON
SW4 Pos. 3 OFF OFF ON ON
Barcode Height
Reduce
Disable Reduce 25% Reduce 50% Reduce 70%
This function is to reducing the spaces between every two lines in every single
paragraph. For SW4-4&5, please refer to the below table before regulate the
percentage of line space reduce.
Effect of positions 4 & 5 on Line Space Reduction as in table below:
SW4 Pos. 4 OFF ON OFF ON
SW4 Pos. 5 OFF OFF ON ON
Line Space Reduce Disable Reduce 25% Reduce 50% Reduce 70%
For switch 4 position 6 & 7, it can reduce the spare space between paragraphs.
No matter how many blank lines, this function will reduce the total unused
space for three particular percentages which are 25%, 50% and 75%. Please
refer to the following table to adjust switch 4-6&7.
Effect of positions 6 & 7 on Line Feed Reduction as in table below:
SW4 Pos. 6 OFF ON OFF ON
SW4 Pos. 7 OFF OFF ON ON
Line Space Reduce Disable Reduce 25% Reduce 50% Reduce 70%
For software switch SW4-8, it can control hardware DIP switch disable or
available. When it set to ON, the SW1 can setup through software switch1
only. The functions of Hardware DIP Switch will invalid setting.
Note: Please reboot the printer after setting adjustment finished.
警 警 警 警告使用者 告使用者 告使用者 告使用者
這是甲類的資訊產品，在居住的環
境 中使 用 時 ， 可 能會 造 成 射 頻干
擾，在這種情況下，使用者會被要
求採取某些適當的對策。
T31454