Posiflex AURA-9000 - Manual (Page 6)

Page 6
3. Close the hood back by press the center of hood
front end; and leaving the tail of the paper roll
coming out of the opening between the hood
and the top cover as in Pix. 3.
4. Excessive paper will cut automatically.
When to Replace Paper
Whenever the printer gives paper out signal or a red line appears on the
thermal paper, it is the proper timing for replacing the paper. Do not wait till
the print engine is dragging the paper roll at the very end. Remove the top
cover and replace a new paper roll as illustrated above to prevent excessive
paper dust in the printer and reduce the possibility of paper jam.
Furthermore, during the standby mode (not in the power off mode), it can
straight to replace the paper roll. The printer will automatically cut the
unnecessary paper right after the top hood closed.
CONNECTING CABLES
Serial Connection
All the external connectors are in the recessed area at the rear
bottom for Aura-
9000S series. The serial connector is a 9-PIN D sub Female connector at the
left in this area. Apply the male connector of RS232 cable to this port for serial
application. The default protocol used in serial connection is 115,200 bps,
none parity, 8 data bits, 1 stop bit.
Virtual Serial Port
A virtual serial port is a redirector driver used in USB interface which is
usually used to create a pair of back-to-back virtual COM ports on the same
computer. It can then communicate using virtual serial ports instead of
conventional inter-process communication mechanisms.
Parallel Connection
The parallel connector is a 25-PIN D sub Male connector at the leftmost
location in the connector area for Aura-9000P. Apply the female end of the
parallel cable at this port for parallel application.
LAN Connection
The LAN connector is an 8-PIN RJ45 type modular connector at the position
left to the power connector in the connector area for Aura-9000L. Please use a
LAN cable of CAT 5 with proper length to connect the LAN connector on the
printer to the LAN HUB as appropriate. Please note that for Aura-9000L, there
must be no cable connection at the serial port on the printer. The LAN port is
10/100BaseT compliant.