Tde470, Sanitation and cleaning, Maintenance – Scotsman TDE470 User Manual

Page 15

Advertising
background image

Maintenance:

Although the ice in this dispenser is completely
untouched, the water and ice vending systems will
need to be periodically sanitized and
de-mineralized. The air cooled condenser will also
need to be kept clean.

Schedule the sanitation, cleaning and
de-mineralization on a regular basis to keep the
ice clean and the machine operating efficiently.

Sanitation and Cleaning

Water System:

This ice machine requires periodic sanitation and
de-mineralization.

1. Vend all ice from the machine.

2. Remove top and right side panels.

3. Unplug or disconnect electrical power.

4. Shut off water supply.

5. Drain reservoir.

6. Mix 8 ounces of Scotsman Ice Machine Cleaner
and 3 quarts of hot (95

o

F. -115

o

F.) potable water.

7. Pour the water into the reservoir.

8. Wait 15 minutes for the cleaner to dissolve the
minerals inside the evaporator.

9. Plug in the machine or reconnect electrical
power.

10. As the machine operates, pour in the balance
of the cleaning solution.

11. Reconnect water supply, operate the machine
for 15 more minutes, then switch it off.

12. Repeat steps 3-11, except substitute a locally
approved sanitizing solution for the cleaner. A
possible sanitizing solution may be obtained by
mixing 1 ounce of household bleach with 2 gallons
of clean, warm (95

o

F.-115

o

F.) water.

13. Unplug or disconnect electrical power.

14. Remove bin top, pour in warm potable water to
melt out any ice.

15. Pull out the vane and bin bottom from the bin.

16. Thoroughly wash the bin’s interior, bin top
interior, spout, ice vane and bin bottom with the
sanitizing solution. Pour some down the bin drain.

17. Reassemble the bin bottom, vane and bin
cover.

18. Wash the sink area with the sanitizing solution
and pour sanitizing solution down the sink drain.

19. Replace all panels and reconnect water and
electrical power.

Air Cooled Condenser:

1. Disconnect electrical power.

2. Remove top panel

3. Remove right and left side panels.

4. Use pressurized air to blow the lint from the
outside of the condenser in towards the fan motor.
A vacuum cleaner hose placed on near the fan
motor should pick up most of the dust. Check for
interior dirt. If needed, use coil cleaner to
de-grease the condenser.

5. Replace all panels and reconnect electrical
power.

Scotsman Ice Machine
Cleaner contains acids.
These compounds may
cause burns.
If swallowed, DO NOT
induce vomiting. Give
large amounts of water or
milk. Call Physician
immediately. In case of
external contact, flush
with water.
KEEP OUT OF THE
REACH OF CHILDREN.

TDE470

February 1995

Page 15

Advertising
This manual is related to the following products: