Sea Eagle Transom Sport Boats & 8.10yt Yacht Tender (10.6SRY, 10.6SR, 12.6SR, 14SR) - Manual (Page 12)

Tie the two rear straps
to the back of the boat
and then clip the front
strap of the canopy to
the rope lacing. Keep in
mind to tighten the
canopy so that it is level
and so that it fits tightly
on your Sea Eagle.
Solar Canopy
(OPTIONAL)
If you purchased the
Solar Canopy Kit, refer
to its instruction manual
for installation. Please
note that our current
Solar Panel setup does
not work with the wide
canopy used on the
14SR .
Light Kit
(OPTIONAL)
LED bow and stern
lights for night operation
of your Transom Boat.
Not intended to meet
U.S.C.G regulations or
to be used with speeds
exceeding 8MPH. Each
light requires four AA
batteries which are not
included.
Dolly Wheels
(OPTIONAL)
Transport made easy,
the dolly wheels mount
directly to your transom.
The wheels lock up into
position once you’re in
the water so they don’t
have to be removed.
The dolly wheels are
not designed to be
towed behind a vehicle.
Swivel Seat Kit
(OPTIONAL)
Designed to provide
maximum back support,
the swivel seat can be
turned 360° and is ideal
for tiller control or the
steering console. Sport
Runabout models can
easily fit a swivel seat
kit on both the back and
front placements.
Once the bolts are in
you can then install the
washer and the bolt on
the underside of the
seat board where the
four bolts stick out.
Use the screwdriver at
the top of the bolt to
hold it in place and at
the same time use the
crescent wrench on the
nuts on the bottom to
tighten the bolts for the
seat mount.
Once the release-a-seat
mount is installed you
can slide the swivel seat
into the seat and place
the entire fishing mod-
ule inside of your fully
inflated Sea Eagle. The
fishing module will fit
snug inside of the kayak
and doesn’t require any
further tightening.
11