Sea Eagle Transom Sport Boats & 8.10yt Yacht Tender (10.6SRY, 10.6SR, 12.6SR, 14SR) - Manual (Page 6)

BTP Turbo
(OPTIONAL)
The BTP Turbo electric
pump comes complete
with a nylon shoulder
carry bag, 12V DC
power supply, hose and
adapters.
Included are a cluster of
seven valve adapters,
with raised numbers on
each arm of the cluster.
The adapter marked
number 1 is the only
adapter needed for your
Sea Eagle.
Take adapter number 1
from the cluster and
firmly push it into the
grey joint that is already
connected to the end of
the hose. To ensure that
the adapter is on as
tight as possible, push it
against a hard surface
like a floor or table once
it is connected.
Connect the other end
of the hose to the red
inflation port at the top
of the pump, located
near the ON and OFF
buttons.
Adjust the pressure dial
to read 3.2 PSI which is
the operating pressure
of your Sea Eagle. PSI
is marked in red on the
dial. Never turn the dial
when the device is
under pressure as this
will immediately cause
the instrument to break.
Connect the cord at the
end of the power supply
into the end of the cord
attached to the pump.
Connect the Turbo
Pump to a 12V battery
(car or marine) using
the alligator clips at the
end of the extension
cord. Connect the red
clip to the positive pole
and the black clip to the
negative pole.
If you ordered the Turbo
Pump Kit you can also
connect the pump to the
portable battery in place
of the alligator clips.
5