SILVA ADC Summit - Manual (Page 35)

Temperature Mode
Wind Chill Temperature Alarm and
Temperature Calibration
Setting Sequence
[mode]
Temperature
Calibration
Wind Chill
Temperature
Alarm
TEMP C 8
18.2 13.2
28.3
Temperature Mode -
Setting the Wind Chill Temperature Alarm
12.6
To Select Setting Display
!
!
!
!
To select the setting display, press and hold
the [mode] button for about 2 seconds to
select the setting display (temperature digits
will start flashing).
When the temperature digits are flashing,
press the [mode] button to select between
the Wind Chill Temperature Alarm Setting
a n d Te m p e r a t u r e C a l i b r a t i o n D i s p l a y
following the adjacent diagram. Check the
'Calibrating the Temperature' section below
for more detail on temperature calibration.
When the temperature digits are flashing,
press the [reset] button to scroll through to
select target wind chill temperature level
(hold down the button to scroll the setting at
a faster pace), or press the [set] button to
select the between wind chill temperature
alarm ON and OFF.
When the above settings finished, press and
hold the [mode] button for about 2 seconds
to exit the setting sequence.
The Setting Sequence
hold
[mode]
hold
[mode]
scroll
the setting
faster
Calibration Setting Display
Check 'Calibrating
the Temperature' section
below for more detail
scroll the
setting by
increment
of 1 step
[mode] [reset]
hold
[reset]
hold
[reset]
Alarm ON Alarm OFF
Wind Chill Temperature
Alarm Setting
Temperature
Calibration Display
18.3 8.3
TEMP C 8
0.0
OFFSET
18.3 8.3
W.CHILL C 8
-10.0
ON
18.3 8.3
W.CHILL C 8
- - - -
OFF [set]
flash