SILVA ADC Summit - Manual (Page 36)

Calibration Setting Display
18.3 8.3
TEMP C 8
0.0
OFFSET
Temperature Calibration Display
18.3 8.3
TEMP C 8
0.0
OFFSET
hold [reset] [mode]
the offset
value
current
temperature
wind chill
temperature
Temperature Mode -
Calibrating the Temperature
12.7
To Select Setting Display
The Setting Sequence
!
!
!
!
Following the previous '
' section to select
the Calibration Display.
In the Calibration Display, press and hold
the [reset] button for 2 seconds to select the
Calibration Setting Display.
When the 'offset value' digits are flashing,
press the [set] or [reset] buttons scroll
through to select target offset value (hold
down the button to scroll the setting at a
faster pace).
When the above settings finished, press the
[mode] button once to exit the setting
sequence.
1) When the temperature has been calibrated,
the ADC will offset the current temperature
by the target offset
value. For example:
If the offset value is +2 and the current
temperature is 26 degrees C, the ADC will
display 28 degrees C (26+2).
2) The current wind chill temperature will be
updated as above accordingly.
Setting the Wind
Chill Temperature Alarm
Note: [set] hold [set] [reset] hold [reset]
Select the
setting by
backward scrolling
Select the
setting by
forward scrolling
Select the setting by
backward scrolling
(fast scrolling)
Select the setting by
forward scrolling
(fast scrolling)