Spohn D06-1500-FLK - Manual (Page 4)

12. Locate the stock outer tie rod hardware and working on the driver's side, connect the outer tie rod to the knuckle.
Do not tighten at this point.
13. Locate the stock upper control arm hardware and working on the driver's side, connect the stock upper control
arm to the knuckle. Do not tighten at this point. Also, at this time, connect the ABS line to the stock clip on the
back side of the knuckle.
14. Working on the driver's side lower strut hardware, add some Loctite and torque to 110 ft/lbs.
15. Working on the driver's side new upper strut hardware add some Loctite and torque all (3) nuts to 45 ft/lbs.
16. Locate the stock sway bar end link hardware and secure to the stock sway bar. Add some Loctite and torque to
32 ft/lbs.