SVS PLASMA ONE 7 - Manual (Page 11)

Electrical Wiring and Lift Control:
Electrical Connections should be
made at this time. The Plasma One
Lift is controlled with a low voltage
24v/ac controller called the Key
Switch Wall Plate. It can be easily
connected to external controllers
like Crestron, AMX etc. This
controller is designed to fit in a
single gauge wall plate and features
a terminal strip for an easier
connection to an external controller
(see figure 10).
Figure 10 - SVS Wall Plate
How to use it:
a. To lower the plasma One lift from the ceiling: turn the keyswitch to the "on" position on the wall plate
and press the toggle switch down. When the lift reaches the down show microswitch, the lift will stop.
b. To raise the lift back to a storage position, with the keyswitch on the "ON" position, press the toggle
switch up.
c. To stop and secure the lift: turn the keyswitch to the middle "OFF" position. The lift will not move
even if the toggle switch is pressed upward or downward.
The toggle switch on the control plate needs to be pressed at all time to activate the lift. It is designed as
a safety feature (the lift can be stopped at any time). The key is an extra precaution as well: when
removed, the lift is secured.
LIFT SPECIFICATIONS
USA International
Voltage 110v/60hz 110v/220v/50hz
Low Voltage Controller 24v/AC 24v/AC
Current Draw 2.3 amps 2.3amps/1.2amps
Materials Steel/Aluminum Steel/Aluminum
Power Requirements: 110v/50-60hz – 220/50-60hz
Low Voltage Controller: Supplied with the lift. 12 pin connector plug. 75' of cable (22 gauge/5
conductor).
SVS PLASMA LIFT INSTALLATION PAGE 11 OF 16
ON
ON
PWR
DOWN
UP
OFF
Grn
Blk
Red
Wht
SVS Wall Plate RP2
1 2 3
4 5 6
7 8
9
12
11
10
Wht
Red
Grn
Orn
Blk
Terminal Strip
Orn