SVS PLASMA ONE 7 - Manual (Page 13)

Position of SVS Mounting Plate:
The plasma screen, plasma bracket and SVS mounting plate must be centered in the ceiling hole. This
must be done before the following step -see figure 12. When installing small plasma screens 40"-42".
please note that the mounting plate can only be adjusted downwards. By adjusting the mounting
plate upwards, the top of the plasma screen may interfere with the up microswitch and prevent
the lift from fully closing. For larger plasma screens, please contact SVS, Inc. for installation
details.
Figure 12
Attaching the plasma screen bracket to SVS mounting plate:
1. Attach the screen's mounting bracket (centered right to left) to the lift's plate and center it to the ceiling
hole. Drill four 3/8" holes in the plate and bracket.
2. Secure the mounting bracket to the plate.
Installing the plasma lift onto the bracket:
1. Install the plasma Screen onto the plate. Again, make sure screen is leveled and balanced. There should
approx. 1.5" of clearance all the way around the plasma. Failure to maintain proper clearance could
damage the plasma screen when closing.
2. Using the low voltage controller, raise the lift towards a closed position. The toggle switch will allow
you to safely stop at several intervals and observe all clearances. Make sure that there are no
obstructions in the cavity where the plasma screen will be stored.
Lift's Tilt Adjustment:
The SVS Plasma One-7 Lift does not feature any backward tilt. Additional tilt can be achieved by using a
tilting PMT 9, which is the bracket used to attach the plasma screen to the boom of the lift.
SVS PLASMA LIFT INSTALLATION PAGE 13 OF 16
24.0"
CENTER MOUNTING PLATE , BRACKET
AND PLASMA BETWEEN THESE TWO
POINTS
12.0"
10.0"