Synaps THD-2800 - Manual (Page 6)

6
Connecting to Digital Receiver
Connect the cable from the antenna to ANT IN with connector
Connect RCA VIDEO/AUDIO jack to TV
You can connect an coaxial single cable from the SPDIF/DIGITAL AUDIO socket on
the STB to a Hi-Fi system equipped with digital audio input. This output is also used
for connection to an external Dolby digital decoder.
Front Panel Information
： ： ： ：
POWER: Power ON/OFF.
CH+: This button makes you change to previous channel or move to the upper item in the
menu.
CH-: This button makes you change to next channel or move to the
item in the menu.
LED INDICATOR:
RED: The receiver is connected to power.
GREEN: The receiver is operating.
USB2.0: PVR Ready and Software upgrade
Rear Panel Information
RF IN: To be connected to the terrestrial antenna.
RF OUT: Output of Digital Terrestrial TV Broadcast signal
AC90-240V 50-60Hz: To be connected to the 90-240V, 50-60Hz AC power.
TV SCART:TV SCART Video output
HDMI: Digital HDTV video output with HDCP.
S/P DIF: Output for connection to a digital amplifier.
:
Remote Control Unit
MUTE: Used to enable or disable the audio.
: For switch your receiver on from stand by or off to stand by.
TV / RADIO: Receiver switches between TV and Radio mode.
NUMERIC KEYS: Used to select channels or enter programming parameters.
RECALL: Return to the previous menu or switch to the last view channel.
MEMU: Display the Main Menu on the screen.
EXIT: Cancel the user selection and return to the viewing mode from a menu.
FAV: To entry and display favorite channel list