Synaps THD-2850 - Manual (Page 10)

10
THD-2850/2860/2880
4.3.7 Favorite
There are 8 favorites group listed in this window.
Press PR+, PR- keys to select one and press OK key
to the Rename window, here we don’t explain any
more.
4.3.8 Auto Standby
Select between On and Off.
4.4 Tools
1. Press PR+, PR- keys to move the cursor up or
down.
2. Press EXIT key or key to move the focus to
the left menu.
4.4.1 Information
When you enter Information menu, you should see
the screen like it displays on the right.
This screen displays receiver information.
You should press [EXIT] key to cancel this menu.
4.4.2 Load Factory Setting
When you choose the option of Load Factory
Setting and press [OK] key, there will be a dialogue
for you to input the password. The default password
is 0000. If you input the correct password, you will
see a screen like beside.
If you choose Yes, all the parameters of this receiver
will reset to the default value.
Note: Please use this function carefully.
4.4.3 Upgrade by RS-232
1. Press keys to select among allcode,
maincode,card,Radioback,keydate defaultdb,
userdb. The default option is allcode.
2. Press OK key at the Start button to start checking
serial port.
4.4.4 S/W Upgrade by OTA
1. Frequency: Use numeric keys to input the proper
value.
2. Bandwidth: Select among 6, 7, 8MHz.
3. Down load PID: Use numeric keys to input the
proper value.
4. Start: Press OK key to start upgrading.