Teac HS-4000 - Manual (Page 106)

106
TASCAM HS-4000
11 – Internal settings
SETUP page (SYNC T/C screen)
Make settings related to the timecode generator on this page.
 
STATUS
When timecode is input, the timecode frame rate is shown.
TC GEN MODE
Use the buttons to set the timecode generator mode.
p FREE RUN button
The timecode generator runs on its own.
p FREE ONCE button:
After the input timecode is captured once, the unit starts
free run mode.
p TIME OF DAY button
If you conduct any of the following operations, the time will
be captured from the internal clock and free run mode will
start.
• Turn the power on
• Set TC GEN MODE to this mode
• Reset the internal clock
p JAM SYNC button
When timecode is input, the unit synchronizes to it.
If timecode input is interrupted, the unit enters free run
mode.
p REGEN button
The unit synchronizes to the input timecode.
p REC RUN button (default):
The timecode generator only functions during recording.
At all other times, the timecode generator stops.
Frame Type
Set the timecode frame type of the currently loaded project.
23.976F, 24F, 25F, 29.97DF (default), 29.97ND, 30DF, 30ND
I/O page
Set the synchronization signal status display and timecode
output on this page.
STATUS
This shows the status of synchronization signals.
p TIMECODE IN
When timecode is input, the timecode frame rate is shown.
p WORD/VIDEO IN
When a synchronization signal is detected at this connector,
WORD, VIDEO or TriLevel is shown.
TC Out Mode
Use the buttons to set the timecode output mode.
p GenOut button
Timecode is output from the internal timecode generator.
p PlayOut button (default)
In timeline mode, the timecode time for playback and
recording is output.
In take and playlist modes during playback, the timecode
recorded in the file is output.
Remote settings (REMOTE SETUP)
Make settings for the PARALLEL, RS-232C and RS-422
connectors.
The REMOTE SETUP screen has 5 pages: GENERAL, PARALLEL,
RS-232C, RS-422 and ETHERNET.
Touch the tabs at the bottom of the screen to open the corre-
sponding page.
GENERAL page (REMOTE SETUP screen)
Make flash start key settings on this page.
Flash Start Key Method Set how the flash start key
operates.
p Flash Start button (default)
Touch a flash start key to start flash playback.
p Standby button
When stopped, touch a flash start key to start playback
standby. Then, press the PLAY key to start playback.