Teac HS-4000 - Manual (Page 52)

52
TASCAM HS-4000
7 – Timeline mode
Setting the file format
Touch the FILE FORMAT tab on the REC SETUP screen to open
the following screen.
On the FILE FORMAT page, set the bit length, maximum file size
and how files are handled when entering recording standby
(pause mode).
The selected items appear light blue. For details, see “FILE
FORMAT page” on page 101.
NOTE
In timeline mode, you cannot select the file mode. The mono
file recording folder setting cannot be changed.
Other recording settings
Touch the OPTIONS tab of the REC SETUP screen to open the
following screen.
On the OPTIONS page, you can set the pre-recording time and
the use of auto markers. For details, see “OPTIONS page” on page
102.
Making a recording
Locate to the recording start position
Use the m[ ] and ,[ ] keys, jump to a mark or use
the manual locate function to locate to the time where you want
to start recording.
When timecode synchronization is ON, recording will occur
at the input timecode, so locating as described above is not
necessary.
Recording
When unit is stopped, press the REC key to put the unit into
recording standby. At this time, the icon indicates this
transport status. In recording standby, press the PLAY key to
start recording at the located point (current point).
NOTE
When stopped, pressing the PLAY key while pressing and
holding the REC key will also start recording.
When timecode synchronization is ON, recording will start at the
timecode from when this unit was synchronized with the master
timecode.
When recording starts, the transport status indicator at the top
left of the Home Screen changes to the recording indicator and
some of the background turns red to show that it is recording.
The time counter starts at the same time.
When the elapsed time (ABS time) from the beginning of the
timeline reaches 23:59:59:MM (MM is the maximum number of
frames), “RECORD stopped. ABS time is over 24h” appears in a
pop-up message and recording stops.
Overwriting a recording
During playback, press the REC and PLAY keys simultaneously to
start recording instantaneously from that point.
NOTE
Recording can also be controlled using parallel control
(except retaking).
CAUTION
When in recording standby, the parallel control signals
output are high for TALLY_RECORD and low for TALLY_
PAUSE.
When in recording standby, the REC and PAUSE keys on the
front panel will be lit.
Stopping recording
To stop recording, press the STOP (RETAKE) key.
Retaking a recording
Press the STOP (RETAKE) key while pressing and holding the
SHIFT key to erase the last recorded region.
The recorded sound file itself will remain as a take.