Tech Source Raptor X11R6.1 for AIX - Manual (Page 15)

Chapter 3 – Software Installation
3-3
After installing the drivers, reboot the machine. Turn on the
machine and the AIX should now recognize the Raptor correctly.
You can verify this by entering the following command:
prompt% lsdisp
If a Raptor 2100T card is present in the system, this command
should return an entry like:
Note: The Raptor cards are identified by the operating system as
follows:
Raptor 2100T
rap2kt#
Raptor 2000-12M
rap2kl#
Raptor 2000-24M
rap2k#
Raptor 2000-24M AIX
rap2ki
#
Raptor 1100T
rap1kt
#
Raptor 2500T (5MP)
raptfp5
#
Raptor 2500T (4MP)
raptfp4
#
Where
#
is an instance number assigned by the operating system.
3.3 Configuring the Raptor as LFT Display
In order to use the Raptor card as the LFT display, use the
chdisp
command to change the current display device to the Raptor
device.
For Raptor 2100T, type the following:
prompt% chdisp [-d|-p] rap2kt0
DEV_NAME SLOT BUS ADPT_NAME DESCRIPTION
======== ==== === ========= ===========
rap2kt0 02 pci Raptor2kt
Graphics
Adapter